In the entire car driving safety, fog lights play a vital role.

The front fog lamp is generally installed at a position slightly lower than the headlamp at the front of the car, and is used to illuminate the road when driving in rainy and foggy weather. Because of the low visibility in fog, the driver’s vision is restricted. The yellow anti-fog lamp has strong light penetration, it can improve the visibility of the driver and the surrounding traffic participants, so that the oncoming cars and pedestrians can find each other far away, thus playing the role of reminder and warning.

The role of the rear fog lamp is to be installed at the rear of the vehicle in order to let other road traffic participants behind the vehicle find in the environment with low visibility such as fog, snow, rain, etc. The luminous intensity is greater than that of the taillight, and it also serves as a reminder and warning.

As an accessory installed on the fog lamp, the fog lamp cover also plays an important role. In addition to playing a decorative role, it can make your car look more atmospheric and advanced, and it can also play a role in protecting fog lights.The material of the fog lamp frame is usually divided into two categories: SUS304 and ABS. SUS304 can be divided into painting and electroplating. The same is true for ABS. The specifics depend on the customer’s choice.

The installation method of the fog lamp frame is very simple. 1. The surface is clean. The surface of the paste must be kept absolutely clean and dry. Generally, it can be cleaned with a cloth that does not fall off with 50% alcohol, isopropanol, acetone or toluene. The surface cleaned by the solvent can be pasted only after the solvent is fully utilized. 2.Before the product is pasted, the product must be placed in the required installation position and adjusted. After the product installation position is determined, the red film should be removed for pasting. Avoid finger contact with the glue surface during operation. After the product is pasted It must be pressed hard to ensure full contact and wetting of the adhesive surface. 3. After the product and the part are pasted, it must not be in contact with water and large dust within 24 hours to achieve better adhesion.

If you are interested in our products, you can visit our official website for more details.