• Gather your materials:You’ll need your rear door moulding trim kit, a cleaning solution, and a microfiber cloth.
• Clean the area: Use a cleaning solution and microfiber cloth to clean the area where the rear door moulding trim will be installed. This will help to ensure a clean and smooth surface.
• Measure and cut the moulding trim: Measure the length of the area where the Rear Bumper Protector& moulding trim will be installed and use a pair of scissors or a knife to cut the moulding to the correct length.
• Peel the adhesive backing: Carefully peel the adhesive backing from the rear door moulding trim.
• Apply the moulding trim: Place it on the cleaned and measured area, ensuring that it is straight and centered.
• Press the moulding trim down: Use your fingers or a plastic squeegee to press the moulding trim firmly onto the car’s surface.
• Clean up any excess adhesive: Use a microfiber cloth to remove any excess adhesive that may have squeezed out during installation.

Following these simple steps, You can install LED Bumper Grille Trim on your car. And protect your vehicle’s body from scratches and minor impacts. Therefore, Remember to take your time and ensure. That the moulding trim is properly align and center for the best results.

FAQs:

Q: What materials are rear door moulding trim made from?

A: Rear door moulding trim make from various materials, including plastic, rubber, chrome, and stainless steel.

Q: Can I install the rear door moulding trim myself?

A: Yes, the car’s owner can install the rear door molding trim. However, It is recommend to follow the manufacturer’s instructions for the best results carefully.